#Ansi Engineering Drawing Standards Software Is Being#

Typically, I wind up doing some simple drawings when I hand off part data to a molder. I (half) jokingly tell customers that I charge triple rate for 2D drawings. ANSI Y32.2-1975 CSA Z991975 IEEE Std 315-1975 Revision of ANSI Y32.2-1972 CSA Z99-1972 IEEE Std 315-1971 IEEE Standards Coordinating Committee 11, Graphic Symbols Secretariat for American National Standards Committee Y32 American Society of Mechanical Engineers Institute of Electrical and Electronics Engineers Approved October 31,1975Most of my career has been spent denying that 2D exists.

Ansi Engineering Drawing Standards Software Is Being

I have also run into one company that uses first angle projection because they work primarily with companies from European countries who use that standard. I have run into companies in the US that do use ISO, or an ISO-ish standard. This should be easy to fix. This is one of those things thatвЂ™s basic drafting class information, and that must drive CAD Admins crazy.I was just re-installing Solid Edge tonight, and right up front, it does have it there, is the choice for ISO or ANSI, but the default is ISO. If CAD software is being installed in the US, thereвЂ™s a pretty good chance that ANSI will be a better choice than ISO. One of those is what country the software is being installed in.

Sending a wrong projection drawing is likely to cost you a lot of money.